Elevator Forum

Not quite 8" from the floor, but I had an older DMC1 that on occasion the door would do as you describe but only about 3 or 4 inches away, but the car...

YAAAY! Based on your daily reset log, you probably nailed it.

WowSounds like Mr. Salesperson got you into a real nice position. No tool, 6 units and most likely a high profile type job with a promised 30 minute r...

What relays are in the MCD/MCE circuit? I think all eight at the lower right hand side of the main controller board. Are the relays a blue color? Prob...

You don't. Like Ib said, If you access the UIT correctly, it'll open up into a scroll type selection giving you options. Ya just gotta know we're you ...

Does it have battery lowering? If so, next time you get this call, unplug and re-plug just the battery back up and see if your controller come back to...

Not sure about johns theory, but I've got a number of these on my route all from the early 90's and several of them based on the KONE service/call bac...

Possibly the parameter for the door open pick up (backlash speed?) is just too low and not enough poop to move the doors? Do they stall at near fully ...

Good answer by halfpick. That was my gremlin for a bit especially with GAL door equipment. The dang relating cable gets hung under the door interlock ...

Ah sorryThat's US Elevator speak for the actual tool name. Portable Computer Display.

If your encoder wheel looks like hell, that may be your trouble. Rail driven encoders can't hardly tolerate even a slight amount of wobble from the be...

Silly...you came so close! I'm still impressed though.

I don't know if there is an aftermarket tool, but the Ascension 1000 and 2000 are completely different beasts. The 1000 uses the straight up PCD, wher...

That's absolutely the worst. "I'm not sure what's wrong Mr. Customer...why it won't do this or that. I'll have to get the Big Guns for this one" or so...

And without a technical support base or an Otis friend attached to your umbilical cord port, your in the weeds when it come to the "why won't it run" ...