Elevator Forum

Do NOT use a bracket for hanging a car. It can get you hurt or killed. Those brackets are for preventing car movement when its still roped up etc, lik...

When I did them on a gen 2, i used rail blocks under the counterweights so when I used falls to lift the car it was exactly where I wanted it to reach...

Canton makes those too. A little labor intensive Install. Good equipment though. I'd prefer an inground over one of those

I'm not sure on pricing. But if it's a two stop, canton makes their own jacks in house. The blue ones. IMO the best jacks in the industry. But only fo...

You my friend are in luck, check your pms

I agree 1000% My companies scrupleless sales folks try this with our customers. The sales folks don't even know what they're talking about. If custome...

Do you have 24vdc on terminal P24C in the COP? If not your power supply toggle switch is bad. This will take out clc comms and still look like the clc...

I'd be doing the same thing. Getting weights and a tach out and adjusting speeds on main valve and rupture valve. I had a car once for a year intermit...

Thanks, very good info to know

Dirt, how are you putting the software on them once you buy the blank chips?I'm assuming you have generic dmc software, but do you have a special sock...

The interface products are the best selector on the market. In my opinion. Very reliable, that would be a nice upgrade

Thanks for those. I'm not sure otis has a newer DBSS manual, has anyone seen one? There's a few faults and parameters in the newer ultra drive that's ...

I'm interested also. I heard a guy from Siemens once mention the existence of a "TK" version of the soft start logic board. Then the parts folks in my...