Elevator Forum

I forgot about bar oil. That's another good option for auto oilers

I personally would only take a can of nylube to throw it in the garbage. I use 10w-30 in an old school oil can. And pour it out of the jug into auto o...

‣ On KONE traction elevators with slide guides installed use KONE guide rail lubricant ISO 320 (part # US53940001) or an equivalent. It is important t...

What kind? The big circle ones? Is it just leaking? If it's leaking tighten all the bolts on it

I wish folks would quit selling out. I know its what folks like to do and go retire but come on. Pass it down to your kids or sell it to your top empl...

Have you tried calling garaventa dealers not local to you? Sometimes you can talk a dealer into helping you out and selling you a part. Side note, I w...

Do you have te book? This is the asme 2000 version since it has redundancy, but is it the normal f1-f8version or the newest version with more dips? I'...

I got you

You need to find a mid test point to determine where the failure is. In this case I'd check the power to the lock at the terminal strip in the control...

Could be a bad cable or connector. I just had a intermediate floor call button not working on a tac 20. I pulled the fixture off and pulled the 10 pin...

I sent you a pm

I don't know, I ain't a guru on this board specifically, but most processors like their voltage where it should be. 4v is very low for the 5v supply.

PSI708-371-2444

I do 10% max from most to least tension suspension member too. What menu numbers do you view the individual load cell values on? The Otis documents sa...

On a gen 2 there's hoisting points on top of sling. It was underslung but they extended the sling stile up past cartop and put a big hole in it for a ...