Elevator Forum

The fault log is in the menu tree in the UIT.

No I mean it's in the UIT.

Check your traveling cable wires, car communication specifically.

You look for it. Sorry, but it's in there.

CRIPHNA 5.Q A is what you need.

Its a 330A.No, what version board is it?

Just curious, what is Windiag 6? TCM? and POME?

I would like some prints please. I will PM you. Thanks!

Check CFC relay. It aids in electrical stop.

The capacitor shorts and takes out the resistor. I've heard of people snatching the capacitor off and just replacing the resistor.

Never had that many problems out of Hydro push button boards but the 400As? Gotta convert them to HFIs and make sure they are properly ground and the ...

Does the car run fine (speeds are the same in both directions) on hand?

Do you have slides guides on the counter weights? If so check for friction mad make sure those rails are lubed.

Is the car running away? Have you adjusted HS on the regulator?

Find the drive page in the prints that has the 1M contactor. Replace each module and go over every contact on that page.