Elevator Forum

Make sure these relays are up:911A90'S60's (all)29's5572TCCI'm assuming you checked all the fuses? Sounds like you have a 2CBC with a Frt? Last ed...

I'll dig up some prints, I'm not remembering a 69x, or 69xi? 65 is a running relay. Find CC (call cancel) and go from there on why the car won't hold ...

Landing Zone Detector= Photo beam transmitter and receiver.

Flat motor replacement, not sure if this is exactly what you're asking about. Kone Machine Replacement Last edited by E-man; 02/26/12 06:50 AM.

I'll find out, none of my TX jobs have Lobbyvision but we have several jobs that do. I just always use the SMLCD in the controller unless I'm working ...

Schindler Lobbyvision?

I was under the impression the SIMM card let's you access and change parameters.

Also on a 330 or TX, press the two outside buttons simultaneously and it takes you straight to car call commands.

Yes. I just did a relief test a couple months ago, I've never seen the car relevel.

I've never heard of an MPHII having a car master issue, MPHI's do. Look at the LED's on the MHC PCB, make sure you have the in service + auto LED's on...

Check the TSLT signal coming from the cartop/door operator.

I've checked the auxiliary contacts and they don't read good, I'm trying to order some but Siemens says they can't find the number I'm giving them off...

Gosh, I don't work on new stuff 🤪G39, MGT on the old stuff. Wouldn't it be in the HHT under Profile - Adjust?

We checked those with a scope then swapped them out with a different car. We did find a shorted AC choke and had it repaired.