Elevator Forum

Most all machines will leak eventually, some faster than others. You want a machine that doesn't have a bad track record for leaking and one that the ...

This one ended up being the close limit.

One thing about the ECI PCBs, make sure and use nylon washers under the 4 nuts. I don't know if they come with them, I didn't see or look for them but...

I just had the same thing the other day and F2 was blown on the DSP. When I got to the MR, I had no safety circuit module wise (the hardwire string wa...

No worries, I do it all the time. Home the little misses is recovering and all is well.

He's working on a Westinghouse MPHII.

104 board. I don't like MAC operators or their shitty door locks but the 104 is easy to replace and dial in. We're doing away with the 105s as they cr...

I've replaced 2 complete "Banner" units (that's the company that makes them so that's what everyone calls them). We ordered them through Vertex but th...

I have seen this before. After checking everything in the controller, I had the generators pulled. But the cars still ran hotter up than down. Had to ...

Try replacing the 12V battery.

If you look at the lens on the sensor, you'll see a line separating the send and receive. You want that line vertical (LED at 12 or 6) so the beam goe...

I'd clean the reflectors and sensors first. Also make sure the LED on the sensors are at 12:00 or 6:00. The FCB's and or HVM's go bad, wouldn't hurt t...

I'd start with a meter on C2 then try pulling them back, maybe a timer not working properly. Last edited by E-man; 08/02/14 02:00 PM.

It's a 1998 TIV, I'm guessing it's an older one?

I tried replacing a TIV CPU once to rule out a problem and just swapped all the chips over and matched the jumpers, it didn't boot up. Is there an off...