Elevator Forum

There is also parameter 7-38 for the smoke detectors 1-0n 0-off. Sometimes when people are having trouble with the smokes the turn off fire service at...

FYI I found what I needed.MG shutdown is an internal timer set to 6 min. not adjustable.The feature only works when the car is on normal, so if the in...

I couldn't find anything in the tool that cotrolls the MG shutdown. I couldn'd find anything in the adjusting manual.there must be something there tha...

Check for a flaky door lock, the interuption can be so quick so as not to generate a door lock fault but still drop the main contactor.

If you have a load weigh strain gauge on the hitch plate that's connected to a LCEVTC board in the controller load weigh set up is straight forward.Ol...

Actually I think Westinghouse was in the elevator business. Westinghouse electric bought K&H and that became Westinghouse Elevator Co. They still ...

MPH2 I couldn't remember the name at the time but it uses the same tool as the Miconic A. So how about a real answer.

Set the car just below the bottom terminal on inspection ( 61N-low 30 and 61U HI.make sure the valve is adjusted.do a shaft setup reset. Menu 6-16 set...

Did that. The tool shows wich calls are enabled but I can find no menu to disable them.

KRMRIF has to be programed by Kone