Elevator Forum

try holding the gov test switch for about 5 sec. then hit the ucm the the reset.

JREP would this cause the oil to look milky? like when your sucking air? oil looks like it has been sucking air, also i have never seen the car releve...

greenpants this i an 8000lbs car, but ihave asked the question about weight, i seems to do it when no one is using it like a voltage drop never have a...

(sccjr) i have checked switches, have not been threw the valve. in your opinion would it be that intermittent? the elevator will run for 4 to 6 weeks ...

can ken a ZAP he is the man~

no tank sensor and the jumper is in the correct spot.

one was installed 5 months ago the other maybe less then a year. i have not looked into cold oil but i will see if they have it on or off.

i didn't know composites could lockout. maybe i don't understand the question what is CS?

agree with solidstate you need to be careful around any elevator! but i will trow this out there, i have had issues with tke fixtures with LED bulbs i...

they need to make a jumper that is "bluetooth" to the phone, you would have to turn it on and off with the phone of service tool, you get to far away ...

what equipment?

check ETSC relay, it not going high or low when it should. sorry i can't remember. i would have to go look it up for the exact fault.

i had a great one...well no so great. just took over 6 old traction elevators, was getting the job cleaned up and the guy with me was going over the m...

have you tried to kill power and shot the "cap"? make sure the doors are closed when you boot back up let them do a learn run