Elevator Forum

Notifications
Clear all

KCM831 vibrations

12 Posts
8 Users
0 Reactions
14.1 K Views
(@ubro96)
Estimable Member
Joined: 17 years ago
Posts: 55
Topic starter   [#24222]
have a 5-floor kone MRL that on Insp it vibrates bad and when you are on auto it's not to bad 'but know I'm getting brake switch faults. I adjust the switch and it's good for 5 or6 days then comes back in. I'm thinking the vibration from the machine is causing the switches to go out of adjustment. I'm thinking the tach is causing the vibration,
Anyone had a similar problem?



   
Quote
(@upanddown2321)
Trusted Member
Joined: 17 years ago
Posts: 96
 
Replace brake switch they are crappy. How are the rails? Dry rails wreak havoc on them. Bad tachs or encoders will usually show as 108s



   
ReplyQuote
(@norcan)
Eminent Member
Joined: 17 years ago
Posts: 36
 
Check brake gap adjustments and set brake switches accordingly. I put a dab of glue on the set screws of the brake switches to be sure they don’t back out. Vibration sounds like you may have a brake dragging on the rotor slightly.



   
ReplyQuote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759
 
I think it’s only the V3F25 drives that monitor the main brake. All others don’t even look at it. Check that one is picking good. Make sure the shoes are straight. If it’s kicked, the shoe has separated from the core and the whole thing needs to be replaced. The switch will still pick but the pad can hang up. If they look OK, I would adjust them both with feelers, nice and square. That being said, tach/Encoder is always a good guess for vibrations/shaking.



   
ReplyQuote
(@ubro96)
Estimable Member
Joined: 17 years ago
Posts: 55
Topic starter  
Thanks for the input. I've adjusted the main brake I'll try the emergency next and put a new switch on it



   
ReplyQuote
(@rolly)
Honorable Member
Joined: 17 years ago
Posts: 729

   
ReplyQuote
(@elmcannic)
Honorable Member
Joined: 17 years ago
Posts: 635
 
Since you’re looking around in the hoistway, be sure to check that the rubber wheel is present on the governor encoder. After a few years they can crack apart and come off.



   
ReplyQuote
(@danzeitz)
Prominent Member
Joined: 17 years ago
Posts: 672
 
We just took over a resolve unit that the customer said it had been vibrating for 2 years and the out of town adjuster couldn't fix it. We tightened up the coupling on the encoder and fixed the problem. Sometimes we make things harder than they are.



   
ReplyQuote
(@bills)
Estimable Member
Joined: 17 years ago
Posts: 81

   
ReplyQuote
(@ubro96)
Estimable Member
Joined: 17 years ago
Posts: 55
Topic starter  
I took the tach off and made sure everything was tight, took out the brushes and blew compressed air in, put back on and it seems a little better



   
ReplyQuote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759

   
ReplyQuote
(@bills)
Estimable Member
Joined: 17 years ago
Posts: 81

   
ReplyQuote
Share:
Scroll to Top