Elevator Forum

Notifications
Clear all

dover dmc-1

11 Posts
6 Users
0 Reactions
20.7 K Views
(@bk2fla)
Estimable Member
Joined: 17 years ago
Posts: 60
Topic starter   [#10009]
hey ya. I have a unit that cycles the doors whenever the hell it feels like it. Already replaced the door board. It doesn't do it frequently enough for me to think it is a lock or gate issue. This is a 2 stop hydro and it does it on both floors. Any ideas?



   
Quote
(@bayblue)
Eminent Member
Joined: 17 years ago
Posts: 29
 
I'd check the programming, also make sure when you replaced the board that all the plastic clips have been pushed all the way through the new board and secured. I'd also check the pick up assys for proper adjustment and door contacts. Check and see if your dcl is leaving enough clearance for the pick up rollers when the door is relaxed.



   
ReplyQuote
(@sccjr)
Estimable Member
Joined: 17 years ago
Posts: 114
 
A couple things. Car door is drifting open off DCL and/or clipping p/u roller as it's drifting open. Another possibility you have another floor h/w door intl'k contact that is interm. opening when car is away from that floor. Remember doors will cycle with open door lock any floor or gate or no DCL.



   
ReplyQuote
(@sbrmilitia)
Honorable Member
Joined: 17 years ago
Posts: 448
 
Yup your limits aren't set correctly, if your doors drift while they are on the limit its not right. You move a limit you gotta do a door scan. No updated door scan problem will never go away.

Common on two speed side slide.

Last edited by sbrmilitia; 03/07/14 03:50 AM.


   
ReplyQuote
(@sbrmilitia)
Honorable Member
Joined: 17 years ago
Posts: 448

   
ReplyQuote
 Boa
(@boa)
Estimable Member
Joined: 17 years ago
Posts: 141

   
ReplyQuote
(@bk2fla)
Estimable Member
Joined: 17 years ago
Posts: 60
Topic starter  
Originally Posted By: sbrmilitia
Seems like a problem a service manager would have...jk

that's just the tip of the iceberg buddy!!! lol



   
ReplyQuote
(@bk2fla)
Estimable Member
Joined: 17 years ago
Posts: 60

   
ReplyQuote
 mjm
(@mjm)
Eminent Member
Joined: 17 years ago
Posts: 23
 
these units will cycle the doors when ever one of the following is opened. Hw lock, DCL, or Gate sw. DR. Note, the damn stroke adjustment on the door operator can allow the car door to "drift" off the dcl sensor. Then the doors will cycle. or HW door lock. The stroke adjustment on the hd85 operator,well, all Dover operators, needs to be strong enough to hold the door shut when there is no power on it.



   
ReplyQuote
 mjm
(@mjm)
Eminent Member
Joined: 17 years ago
Posts: 23

   
ReplyQuote
 mjm
(@mjm)
Eminent Member
Joined: 17 years ago
Posts: 23

   
ReplyQuote
Share:
Scroll to Top