Elevator Forum

Seems like a major headache for basic UI. A lot of unknown variables here... Not saying it can't be done but trying to communicate with hardware/softw...

^^^ couldn't agree more, I too have also seen that.

I'll be near a two landing mid 50's build tomorrow, might take a look at the prints or at least take a few pictures...From what I remember the prints ...

I've worked several of these units, although infrequently, 4hrs seems like enough time to make some headway. A close set of prints should be more than...

Depending on the CRIPHNA version and build I've had several boards that needed to be repaired because of the R176 resistor burning up. Most common sig...

What have you checked so far? Have you plugged up your tool yet? Is it saving the pulse count? I've seen some DMC'S that will run doors slow just beca...

I don't have any complaints, have quite a few on service and have had very few problems. Tech support has been good but I've only had to call a handfu...

Just....why.... would someone install something like that? Evil. Have you looked into other options? I'd be willing to leave it mounted to the door an...

Jeeeze cancer really sucks. I read a ton of his posts and the guy was extremely knowledgeable and helpful. If it's not to personal how old was he? RIP...

For reference in case the last board you replace doesn't cure the holding hall calls. the original host/forums/ubbthreads.php?ubb=showflat&Main=35...

Just the other week I removed 17 high school students from a 2500lb car. Guess they thought it would be funny to see how many of them could fit. They ...

Obviously it's going to depend on how much water you think is in the unit, typically if we suspect there's quite a bit we will drain and replace the o...

I'd check the programming, also make sure when you replaced the board that all the plastic clips have been pushed all the way through the new board an...

It was a mistake, the older elevator was demo'd and they had Schindler install this newer unit. We work on the majority of the elevators for this part...

I believe this gentleman was in a basement machine room with an open hoistway trying to access the car top by stepping on the shive. It seems as thoug...