Elevator Forum

Put this one to bed. Apparently the route mechanic had a vane pile up on the MUS & MDS mags (mfs sw’s) a few weeks back. He remounted the MDS &...

Unfortunately our IMS tools are 2.4.x.x. We need to get our hands on a SLTA PCC 10 Card to get this LN loaded with the right config file.

Bad new motor encoder from Kone. Read good on O-Scope but for some reason did not work when hooked up. Installed another new one from Kone runs like a...

Motor is hooked up right. I’m truly believing we have a bad MX 10 motor stator. During a high current demand with an initial start up the machine simp...

I believe so, but I’ll need to verify this to be 100%.

Thanks for the reply. Meaning stator is bad or I need to change the stator resistance parameter? The machine will pick the brakes and try to drive dow...

Got it. I tweaked on the F pot on the DAR board. Been running with no faults for 8 hours. Thanks for all the help.

MG. I pulled a new tach cable outside of the piping and shortened it as much as I could. No tower interferences.

23

Got a 5000 tripping out with a 23, 24 flt only in the down direction, different spots in the h/w. Travel demand is 500fpm actual 497. DAR, REG Boards ...