Elevator Forum

Glad to hear it.

Just make any adjustments you may need to. Should run with default adjustments.

Same cable. Run Hoistway Setup.

Yes, RS232 port with standard serial cable. You will need IMS to setup if you don't have a UIT on the controller.

Tool will still connect with dead battery. You will just need to do a hoistway learn if you loose power with a dead battery. And I meant to say CLC, n...

Is the red LED on, on CPU. Board in COP?

Did you run SPC command?

Connect serial cable to CPU 188E board.Open Hyperterminal, create new connection.Set Hyperterminal for COM1, BPS=38400, Data bits:8, Parity:None, Stop...

Also check tape guides. I like those because you can flip them and get more life out of each guide.

+1 on the valve. Oil takes more than one run to heat up.

Yes, if you have IMS you can inject an IO.

I'd like that one also if someone has it.

Go to Help then Install Password. That should tell you.

Never had one turn off when I made a change in IMS. Are you changing CSW's?