Elevator Forum

hey len, a friend of mine is selling his World DMC tool, if you do not get it from solid state, pm me and i will give you his phone number. i believe ...

the dover generators that i have worked on, have the brush rigging pinned. you are not able to move the rigging to adjust neutral. I have removed the ...

car is over compounded. decrease the series field strength by taking out some of the turns in the series field. you want to keep the voltage at the ge...

sounds good to me, that should really make the damn numbers good. keep us posted,

i have had this problem with a couple of different cures. one is as e-man says, make sure the sensors are aligned correctly, if not the can intermitte...

with all that water damage, clc probably bad. you can check the selector inputs by unplugging the communication cable from the selector that goes to t...

does not seem to be possible, i do not see anything that will park the cars with the doors open. At least not in the manual i use

I have tried a few of them, the ALURATEK is the best one i have tried. I use it with my toshiba notebook. it is 99 percent reliable. also have the TRI...

this could be tough, i have had a couple tough setups, but usually the light will go out and abort the setup just as it leaves the bottom floor, usual...

pulse count in wrong direction means that the phase A and the Phase B selector pulses are not coming on in the appropriate order. the selector knows w...

i also have a good generic print, shows all the nomenclature for the relays. looks like hi speed should drop when you get "S" to reset off of the uhs ...

Poons, when the car goes into nudging, the doors are restricted from re-opening, they will only stop if the door open button, or safety edge is activa...

bummer. did not think that site would last to long. hope you did not get a program that will expire soon. thats really strange, that site has totally ...

tool is not that expensive, could have paid for itself with just this one call. it could be a lot of things, you need to get a tool to see what mode t...