Elevator Forum

i have done it before, it has been awhile, but it was fairly easy, just had to add a general purpose i/o board into one of the slots, i can't remember...

sorry about that, had a couple beers, thought i was being funny, sorry to offend you spittman, you did say 4 computers, and you did say you had the pr...

spittman, are you smoking dope, read your original post, 4 computers, read your other post, problem resolved with some fancy converter, and finally, w...

you took out one of the input chips on the cpu board, this is a typical trouble call, when the board jumper is not removed. need to look carefully, it...

i thought you said it was happening on all 4 computers, do you only have one cable for all the computers?

sounds like the main controller is displaying FLT on the screen, Ive seen this a few times, and it is usually the solid state starter that has failed,...

i also looked through the manual, seems like it would be an option somewhere, but i could not find any. maybe you could enable card reader operation, ...

sorry spittman, i thought you were new to the program, i was giving you rookie advice. that is strange that they all do the same thing. i do remember ...

i would suspect a compounding problem, make sure your SF relay is working correctly. if you are getting the same voltage across the generator leveling...

if it comes up with unable to open com port error 45, then the com port is not configured for ACPI . you can check to see what the port is set to by n...

i think he is saying that all the direction relays are coming in when he inspects down, but the car does not move, i.e. stalled. is this correct? if i...

you don't need a special tool for kone elevators the world freedom tool for kone is only for the mac 105 and WG door operator

i still think i should get half a picture, my answer was theoretically correct ha ha. ill still donate 1/2to broke.

to make sure the conductivity of the circuit was sufficient. had to set the tube to fire thru the rag and your body, cause some people have higher res...

you can get just a null modem cable, or you can use the rs232 cable you have and purchase the null modem adapter as rolly noted. null modem is not an ...