Elevator Forum

UpandDown2321
@upanddown2321
Trusted Member
Joined: Jan 1, 2010
Topics: 1 / Replies: 95
Reply

Thats strange. When you scroll it shows the proper number of landings for the job? I cant see how it would without a shaft learn and a new CPU. If rol...

8 years ago
Reply

With the new CPU it should only be a few paramters to start1-31-23/241-861-95 Then roll call direcrion which would really only screw up top and bottom...

8 years ago
Reply

What I mean is does it attempt to run and abort? Or just sits without attempting to learn at all

8 years ago
Reply

Does it try to shaft learn at all? You need to be just below the floor to start. Changing a CPU ive never needed to do a door learn first. A 5 7 1 wou...

8 years ago
Reply

Yes that is correct.

8 years ago
Reply

What type of drive is it? Is the load weigher reading correctly? 41 is an ebrake fault. Did you check that switch and E brake assembly. Also inspect t...

8 years ago
Reply

Yes 5%. Ideally you want it set at -2/3 at the bottom. Run to the top and it should read fairly close. The Offset pot will set this. The gain shouldnt...

8 years ago
Reply

Replace brake switch they are crappy. How are the rails? Dry rails wreak havoc on them. Bad tachs or encoders will usually show as 108s

8 years ago
Reply

Adams Hatch Latch can be installed. The newer style boards seem hold much better than the older style boards. As long as you can get 120VAC to it you ...

8 years ago
Reply

Old thread but this is usually solved by turning 6-12 to 0No drive stand by mode...Some drives take years to show that problem others only a short tim...

8 years ago
Reply

If you plug in the configuration switch and turn it on you will wipe the carstation. If you go that route just be sure to have all keys for switches a...

8 years ago
Reply

It does. Some of the important ones are. Not sure if I missed any1-31-23 / 241-86 Earthquake1-95 Drive TypeMenu 5-4 Roll call direction also needs to ...

8 years ago
Reply

The governor switch fault and 98 is another ADON relay fault. Has the ADON been changed? Its a quick change. This car has front and rear? Also check y...

8 years ago
Reply

You also say you showed up to boards lying around. Was the mailine out for a while? Its possible critical CPU parameters...controller type...drive typ...

8 years ago
Reply

The shaft communication should come up when the car has taken a learn trip. If you scroll to try and put a car call in im going to assume it shows alo...

8 years ago
Page 6 / 7
Scroll to Top