Elevator Forum

CLC adjustment 52 and 56 should be set to 3.

In the $800 range.

Actually it may be a 100 ohm resistor.It is silk screeed with a 1000 on it. It might be 100 with 0 zeroes.I tested a resistor with 393 on it, and it w...

Is your bus voltage above 700v. Any AC on your bus voltage. Check your (3) 50 ohm charging resistors. Does the fault occur right away, or does it show...

Tac50-04M have cna cards. There is a 3a pico fuse hidden behind a connector. Hcp should be on that that group cna card. If the cna card is bad, borrow...

The selector has an encoder count also. the 1062 is usually a gap in the slowdown magnets, or sometimes to short of a slowdown distance. The Tac22 is ...

Almost always the safety edge cable or microswitch, rarely the photoeye cable. Remove your safety edge cable from door board and ohm it while manually...

Having same problem. Tried updating CLC to 4 chip software(AN13), so I could get PI timeout. Have done this over 50 time without issue. Get 25 fault(t...

escutcheon

Its almost as if LCC7 is not connected to Clc board.