Elevator Forum

That prints seems to show the wiring plug connector A pin 16 and doesn't show the back of the card.

Hey jkh I don't think prints say what you think they say.Where it says typical intermediate cards, it refers to to the intermediate slowdown inputs. M...

99.99% sure its the power card. It has the off delay timer keeping msa relay up for 1/2 a second for the soft stop. It has failed.

You say its a DMC 1/A but your software is for a DMC-1 that has a selector and is for a clc 6300bp4. Dmc-1/A software for 6300bp4 is 675DL**

Double check Neutral first. Many motor shops use the AC way of setting neutral which is not adequate. Grab your battery and bi-directional ammeter and...

The person who bound the Lon system forgot to upload the Lon node database to the 188e board before he left using Lon explorer. Get your Lon cable out...

Back in 1990, we had this issue. We were using bulk cable at $.11 a foot. Factory was charging back then, about $.80 a foot for galvanized aircraft ca...

I believe you located the correct low temp thermostat.On submersible unit, it should be bolted to the crossbar motor mount above the motor. Unless you...

Actually the SE input goes to the door board, and the door board takes care of reopening the doors. The door board sends the SE signal to the CLC thro...