Elevator Forum

Level sensor is exactly what it says. Either your up level or down level sensor isn't changing states when leaving the floor or coming into the floor....

You can do that to but in my honest opinion it is easier to program a few I/o's and a rs5 board. Its all about the card reader control panel on their ...

If you can try swapping drive w/ another elevator. Theres tons of other checks you can do but if mce told you it was the drive go with it. Don't feel ...

Great points...He is okay with escalators and he said 80% of his units are montgomery escalators. I personally would go crazy at the same job everyday...

I have tons of problems with PM contactors on mce cars especially with the aux contacts on them. I believe theres is an input to the drive based on th...

Sounds like your up terminal limit is not made or your OL contact is intermediatly acting up...car wants to drive up. Whats stopping it? Your LOT is a...

I think just the opposite of you. These videos show how complex our job is. This guy is a great all around elevator mechanic and he does a great servi...

Anything can be done with a few relays and some electrical skill set. I actually enjoy doing these type of projects. Its like doing a mod and keeping ...

Its most likely magnets that moved into down slow down lane. Check back of tape for term slowdowns as you know tac 20's dont have actual term sw's. Ma...

Good job creating this fake troublecall and trying to use it as a sales pitch. Not working bro. Take that ish somewhere else.

Just ran into a new install job spec'd for this 3300 out here in TX. My vendor can't match the spec or anything similar, so Schindler is going to be t...

Well its nice they dumbed it down by adding the same connector as the siemens. The s&s doesn't normally come with that connector so you will have ...

Its been awhile, try to go ccw on the check. I believe thats least resistance. If not go the other way. Its like a hydraulic valve in the tank w/o an ...