Elevator Forum

Looks like my service tool is not communicating through IMS. I have another service tool on order through a nameless source. Is the UIT readily availa...

Yes.

Not that I'm aware of, but if you suspect one of your sync sensors are bad you can jump the input signal from one side or the other. For example if yo...

Flt 7 is a SH1 OR SH AUX contact open during run. Pull the wire during a run and see if the same flt sequence is created. Also 57 is communication to ...

Replace Drive. 400A's notorious drive killers. Also check motor encoder.

Thank You.

Check your up to speed contact on your soft start. When the Tac20 faults out it kills the control power for the soft start. So you can never tell what...

I believe there is a software upgrade for this problem. It has to do with the dispatching. The car tries to answer an above call and drives itself int...

I did transient into local 18 and yes when you are working as a transient you will be the 1st mechanic or 1st apprentice let go. If you are considered...

If you are a Probie working in another local is near impossible because they have their own hiring list of probies, but if you are a 1st year apprenti...

Hey guys just reading over some of these posts. I've been in the industry for 10 years. I was a navy electrician and transitioned into the elevator tr...

A couple things. Car door is drifting open off DCL and/or clipping p/u roller as it's drifting open. Another possibility you have another floor h/w do...