Elevator Forum

I've changed two of these before without pulling the ropes. On a car today at another job no luck kept getting encoder faults had to remove rope and r...

Turn off the disconnect

Nope

Negative I dont remember the command but you dont hsve too. That encoder has goofy way it connecte to the shaft pay close attention when you change it...

Which MRL machine? German or Torin? absolue encode is on the machime change it perform a ecnoder calibration boom goes the dynomite

Video says its private and im unable to view it

Originally Posted By: Postal I can tell you how Call a competent evlevator company they'll be happy to send someone right out We elevator guys are b...

Board prints?

We had a safety stand down last week due to this this. It was a Friday afternoon. Richard was going stop by check this out then go home. Reported the ...

I think the DMC was god and we should still install them.

Have you checked all your solenoids? Last edited by sbrmilitia; 11/20/13 04:01 AM. Reason: Im retarded

My company took a high rise full of these. Do you know what year millennium? From what I hear good running equipment but a real test troubleshooting. ...

Originally Posted By: Postal Done several of those conversions!! Great product, uncle TKE said those are on back order last I checked I don't know ...

Nope I was told to use my PDA/Laptop. What really stinks is my 6400GE4 boards have no UIT. The Fast made it super simple to do a door scan and make ad...

show me the reset on a relay logic dover