Elevator Forum

Those are hard to find!!!

It just might help if you said what type Otis controller and Hydro or Traction.

Also depending on how much the voltage has decayed, if these are the main supply, look for higher voltage is you replace them with solid state. If the...

If you have a Miprom Black Book, have you followed all the notes when replacing the Boards?

DMC fast tool is easy, but to do all The Tac20's you will need a Echelon Lon interface. If you have the 2.4 series IMS you can use a rare PCC-10 card ...

I have a Thyssen mod article on it.. send me a PM with an email and will mail it to you. It is 22mb so make sure email takes attachments.

Just be sure brake sw's are good. Maybe take brake sw out of parameters and see if it still shuts down. Always floor level could make it think brake d...

I had a 211 board that shorted layers in the board after a power failure in the bldg.

Private Mesage me an email, will send..

You can log in with hyperterminal at a 19,200 baud rate and do a BITD and see the states of bits, Set or Reset. You can also change them. Last edit...

Lord help you on a TMS 200. I worked for Kone Tec Support and it took me 4 weeks to get a 2 car group to stop chasing calls with jumper configurations...

Probably the RBI board in Machine room or the filter caps on the power supply. Two caps on Power supply and they use a voltage doubler circuit which s...

Inspection in Car

INSTALLHUDSON.BAYSNOW-FLAKELIGHT(SP),BAR (SP) is space barNotice they are all Upper Case