Elevator Forum

So long assholes!

Just a fact no opinion at all.

Greenpants you are so full of Crap. Obviously you are an ass. I personally spoke to the stock room attendant and he told me exactly what he did when h...

NYTECH PM me an email can send you what you need! I was Kone Tech support for this product.

It is possible that someone programmed the unused PLC output to do another function if there was a bad output. It's PLC ladder logic and if you have t...

Check with Access Electronics to see if they can repair the board. Bet they have seen this before.

Check brake resistors on swing doors. Common problem for them to open.

When I worked at Otis it was 500%. Probably more now!

Did you happen to go from a 16 bit tac20 to a 32 bit? Does your IMS support 32 bit and have a CPUA Icon?

Also the 3 phase monitor/Phase Detector is a POS.. Can do that.

Those Sensors are very touchy. Have to be right on or an error is set. You can watch them with IMS as the car runs.

The DZ and Leveling sensors in the car top optical reader box are not set correctly.

PM me an email address!

There is software called HHT that emulates the Westinghouse/Schindler tool. I believe it was orig made by Dover. It works very well.. Have to install ...

I believe 112 is Low Pressure switch is activated. 25 should be Pit switch pressed.