Elevator Forum

Question 1; Does the elevator accept the calls?Question 2: Did you change the CLC for a BP4 with new software for the BP4?If it is BP4 with new softwa...

Question wath is a BART tool ?for use fast tool sofware you have to change the serial port to ACPI inside the control panel and swith to normal 232 wh...

is rope loadweight?, try to disconnect the loadweight CAN, then a "tecc" and reset the cpu, check if you can move the elev with doors disabled

ebcom sw position on each car ?

Originally Posted by EMEEL LLC Hi,I got problem with Shindler hydraulic elev 330A.The elevator does NOT run in Normal or inspection and the screen sho...

NOTE: Whenthe car ls on SCA(SeIactiv8 Collective Autornatlc) and level wIIh a Floor, SI should be 24 VdC. When the car norms, SI goes to 0 VDc.Upon re...

""The problem is to do a lot of the basic things you will need to learn telegrams""what this mean?use a hyper terminal?

PM

move the cab to 2nd floor, open 1st floor door, comfirm all magnet on selector tape are alingned and in the right spot (use the Otis selector tool for...

ADAMS Elev , check in OTHERS OEMs next Payne Catalog V18 page 402

funny 🙂the one to troubleshoot and adjust the controller

yes I-View !

Originally Posted by solidstate I have been told that the "S" folks remove the sim card when they lose the maintenance. True, the SIM card is a tool...

thnks