Elevator Forum

Sounds like your roll call is backwards

Jumper

Welcome brother

Stuck landing call

I would call your local tke office for proper UNION mechanics

Does it fault out at the same floor?if it does then replace junk eci drive block and contact assembly.

I got it,idont know the numbers just 41 anf 29 had a bad door close limit.car would take all calls but sit with doors open after a run.

Did you ohm out the inspect switch?

If u can get something to monitor power to machine room that would be smart,had a job burn up 2 motors in a year and the 2nd one 2 wks before the full...

You might have corrupted software

Sometimes it takes a few tries

Did u try to teach the hn? Type in dhnf

Its in the tke parts book