Elevator Forum

I have had to move the bottom normal down a bit to get the hoistway count to save

I changed all the finder relays for the schrack. Been running for over a week without out any shutdowns. It had to be reset at least once a day before...

yes they are blue. I seen on around page 12 what they are. All the valve pilot relays and muts. ordered all new relays for controller. will see if thi...

I had a similar issue. Started happening every once in awhile then about everyday. I replaced the power supply in the controller and it never happened...

I ran into this a few times. If its a door board from an older revision you should replace the board. There are some resistors in the top left corner ...

Is it losing the pulse count right away? Does it run ok for a bit then lose selector count?

What relays are in the MCD MCE circuit?

magnets are good and in place

Boy this thing is being a pain. Ok I haven't dropped the soft start in awhile but its still faulting out. getting faults 1087, 1009, and the 1078

I did see it fail. It lowered to the bottom to warm the oil and the motor energized for a second and kicked off then energized then kicked off then th...

It does not have battery lowering. I adjusted the bypass(low pressure) port per manufactures recommendations to rule that out but it still shutdown. I...

I have changed the battery in the cpu card with a new one and it is still shutting down

Thanks, I got it loaded. Bit of a late update but better late than never.

I am not entirely sure how to set it up. What are the steps you usually take. Maybe I'm missing something?