Elevator Forum

Jumper configs are correct.

I seen the jumpers. I know they have to be set for a front or rear opening. I set the jumpers exactly how the old board was set up. But I will take an...

We have had to have our older units fitted with new custom guides supplied by a local macnine shop. You may try Elpro inc, or ELSCO for guides that ma...

the PA6 took the place of the PA3 so i was told by the supplier TKE

I am not very good with the IMS program. We just haven't had a lot of TAC units.

This also has a rear door. so just to try it, I hooked the rear board up to the front. IT worked exept open was close and close was open. I can only a...

The IMS can communicate. Going through the set up procedure it has you check the limit functions by using the manual open and close buttons. But the b...

I talked to world the other day. They told me they couldnt do anything with a TAC??

assebly #6300 PA6

the label on the board reads: Warning- This board has factory test software. Please verify and upload all necessary software and configuration. How do...

ADA yes. State Code no

replacing the door operator control board fixed this issue. The aux. contacts are located on door board

what I found is the LIM led is staying high when the doors are closed. There is a microswitch on the car door frame that when the car door closes it m...