Elevator Forum

Originally Posted by Montana I use a jigsaw on slow speed and cut real slow. I usually go through a couple blades. this also works for me. Or good o...

What operator is it? Is it the HD or single belt (LD)? either way I would say door motor/encoder is the issue. Possibly a landing system magnet issue.

youtube.com/lindenelevatorRoy made some videos of maxton/eeco/dover valves that are very helpful. Other then that its all about experence

I think it uses the black tool but dont quote me. Only real issue I have seen is the power feeding the contollers is NOT enough amps so Otis adjusted ...

Run the elevator to the top floor and look from the lower floor (if its 2 foors, or middle floor if its 3) and watch the upper and lower pistons on bo...

Will expando come apart if you need to replace the valve? Or not going to happen?

Originally Posted by KSNY I can tell you: that its a slow moving car (~100FPM)the capacity is anywhere from 1500-2000bsI can tell you that it needs a ...

I can tell you: that its a slow moving car (~100FPM)the capacity is anywhere from 1500-2000bsI can tell you that it needs a worm gear packing asap due...

On some controllers you can turn on B44 then turn on DLM but we were only able to do a few this way. For the most part we installed an external DLM

Air in jacks, check valves not set right, pistons not bottoming out or could be leveling speed in up is a little to slow if its a terminal floor.... I...

bumpTakes the call from the contoller

bump

When changing the address from 2->3 @ the 2nd floor and 3->2 @ the 3rd floor the problem then changes to the 3rd floor. The elevator is 4 stops ...

bump.