Elevator Forum

Both MCE & GAL are good controller. But they make a simple thing to become complicated just like westinghouse/schindler controller. I install both...

None,All the peers give you good advice.By my experience, check your mg or motor netrual. A lot of time mechanic change brushes and move the holder wi...

Thanks, I thought of same thing. Just want to confirm with other peer. Look like kone really make a bad drive on this one. I know guys from other comp...

You can try out this system from SEESFit Pit water abatement system.www.seesinc.comGood luck

try this sitegood luck 🙂

This is the Mag Explorer software. I don't know will it work on DSD412

The customer may be able to getting the manual but I don't think Kone will sell them the tools.Guess, I have to do a little search or fly there then :...

battery may be dead, did you check the parameter?

world tool is not a very good one to use on DMC, some version of software will not display the parameter correctly. Use Fast tool or IMS. I agree with...

Yes, you need the tools to get in to change parameter and perform learn trip.

UpdateFinally go back to the job.Have to replace both power supply and the CLC board.Do not know which one causing which go bad.Re-program and re-lear...

60's relays are the inspection relay.I cannot found any print that have 69x or 69x1westinghouse using 69 relay for parkingI agree with E-man and Scott...