Elevator Forum

Notifications
Clear all

schindler 330a

7 Posts
6 Users
0 Reactions
14.9 K Views
(@scottsr)
Eminent Member
Joined: 17 years ago
Posts: 11
Topic starter   [#4666]
I have a 330a two stop that has been off for about a month. It Was running fine previously. Went into the machine room to do an annual test and foud no screen reed out ; found the 24v logic voltage supply was no good and changed. Now I have a reed out of "BLOCK READY 0=01 1ii unv". Attemted to reset many times to no avail. Can not even run on inspection. Does any one know what could be wrong? Much appreciated.



   
Quote
(@kenelev)
Estimable Member
Joined: 17 years ago
Posts: 104

   
ReplyQuote
(@elevatorfella)
Estimable Member
Joined: 17 years ago
Posts: 102

   
ReplyQuote
(@elevatorfella)
Estimable Member
Joined: 17 years ago
Posts: 102
 
Well,don't think there is a battery backup, RAM board will hold parameters, agree try' jumping pressure sw. Sad to say its a Schindler, you never know. Unv means unavailable. Did you do a reboot? Press button on the board that is mounted to the Main relay board 3times in 1sec. Intervals,then when screen shows system boot, press and hold for 5 sec. This will reboot entire system. Sometimes you have to put controller on MR inspection. This clears most errors.



   
ReplyQuote
 Len
(@len)
Estimable Member
Joined: 17 years ago
Posts: 194

   
ReplyQuote
 mbke
(@mbke)
Trusted Member
Joined: 17 years ago
Posts: 41
 
no no. hit the reset button on the gcio360 board one time .when the red light on the board blinks twice hit it again. if it was the pressure switch it would read PSW.



   
ReplyQuote
(@jblack83)
Estimable Member
Joined: 17 years ago
Posts: 143

   
ReplyQuote
Share:
Scroll to Top