Elevator Forum

So, this unit has a PLC in the controller?? Please verify which inputs are lit. (both rows)

Pull the motor and take it to an electric shop. Either the capacitor (in the grey box) is bad or the centrifical switch is bad or there is a problem i...

How old is the unit? Where is the car physically? What does the 24vdc supply measure? Does re-leveling work?

Did you ever get your problem resolved?

Rotary was a Oildraulic manufacturer around the late 30's or early 40's. Some controller companies used red/green for line and common (not necessarily...

P-56 is an OLD valve, Someone might have a write-up on it, but they are not going to let it loose easily.. What part of the USA are you in? Good Luck

coil identity is on the back of the board or at the connector if it is a slimline relay. Make sure that you have the correct coil in the relay. Are ca...

I think I have an old VVC-1 MCE black box iif you want it, just pay shipping. I am in Oregon

If lamps glow without a call, your grounding on the controller needs to be paralled

Do the call lamps on the card glow dimly? are they on strong? Have you checked the springs in the intermediate floor switches? Does the gate switch ma...

That is an Artira

Is the manual operation in the correct position?

Check your DCL, it has to be open for car to run.

When a customer contracted to have a WOV product installed, SOP would be to get a generic cut sheet of the product with the features required and the ...

Most of these had mechanical locks and not electric strikes... I would think that a previous WOV deale3r could handdle any problems with a unit like t...