Elevator Forum

So I see PLR is position loss recovery. I changed thst battery as well. It’s the 5th 12v battery in the controller. It’s also charging. I have 12v to ...

Now getting a 2833 PLR battery fault. Changed my 6 12v batteries in the controller. Still no safe safe 2. Car safety circuit is good. What is PLR batt...

I have had trouble with their car top inspection stations. Does it have the long cable ?

So GTC. CSC and OS had to jumped out to run car. Found the jumping points. Now gotta try and reset all these things Last edited by Jluff; 10/06/22...

I got the OS. P26 4-5. But need the gov or sos ? By the way. This is a GCS control system Gen 2. Regen drive. With a machine room Also What is input g...

What’s the 0026 sub code

Thanks dirt. 👍👍

I looked at 2 other Tac 20s. On these the MUTS relay was mounted above the main cpu board on a terminal strip with coil wires marked underneath and wi...

I definitely have no suppressor wired into my MUTS coil terminals. Is this standard on most Tac 20s ? I’m going to check out some other ones to see if...

I am looking for this suppressor right now. Vertical express says they do not stock it.

Travelling cable is the problem. Definitely not mounted right. Not 40 times the diameter of the cable from hanging point .. was rubbing on a concrete ...

Yes