Elevator Forum

When the car stalls an 1" below the floor in the up dirrection and you have a floor command of 3fpm! Is DZU up?

Cucuvator,What part of the safety is breaking?Who is the manufacturer?Are these safeties being used on a elevator that runs under 150fpm?How much does...

The relay board terminal markings remind me of Vergina.

PM an email address to me...

Could it have anything to do with the PC Node setting?

I'll send you what I have for that drive...

I'm no expert with this tool, but let me ask you this. Did you do the job setup before connecting to the controller? If yes, did you disconnect it fro...

I wonder what would happen with a full load in the car?Does this unit have dynamic braking?

I'm with John Jay,If your stability pot (R4) is set to high it may act that way...

PM your email address.

I personally would need more information. See if you can find the following information out;Manufacturer - Otis?ModelError codesWithout these details,...

Just a few thoughts...Do you have any info for that drive?Do you have the setup sheet for this job?How long of a delay is there between drive enable a...

I did pull the image from his avatar. And it's from his posting in the "Employment" section of this forum. Again, I want to reinforce safety. My thoug...

Henry,Because of the age of your equipment, we will recommend it to be Modernized. Try and post a short video of the hoist machine running. Which ever...