Elevator Forum

Car is back in service, had to change the LCECPU, Drive board, and Cartop board and update the software. Finally got a successful learn of the hatch a...

Thanks guys, I got a hold of a manual that showed how to navigate and that was the first thing I checked, it was set to 1 which I believe was KCM831 h...

Thx for the reply, im going back today. Ill replace the battery first thing. Any chance you have a manual on these?

Perhaps another elevator company that maintains or installs them would buy them? Their boards are interchangeable so i'm sure someone will have use fo...

I knew TK aquired CE but I didnt realize it was pre Futura. Worked on the 5000's, Meridias, and Futuras, but ive never seen one that looked like this....

I have Prints if you still need them, PM me.

I would parallel a relay off the end of the safety circuit with holding contacts and see if it drops the next time you get a call. Perhaps it's a bad ...

Wage rates differ between Locals. Local 1 negotiates their own contracts so things work a little differently with them but I have seen the Local 3 and...

CLC is your main board in the COP. You can buy them new or get them repaired from World Electronics.

what kind of doors / operator do you have?

Looks Like a Duplex Payne relay logic controller. Do you need prints?

Assuming its an I Motion I would start by relearning the door. If you still have issues I would test or replace the limits, sensors, and relays on the...

Agree with Indirtwetrust, we picked up a few of these but before a contract was signed we had the customer order the blue tool for each location to be...