Elevator Forum

Thanks

Try swapping input board for close. You might have one for heavy doors which isn’t being used.

I had same issue. Turned out to be the board (I forgot name) on top of car that sensors plug into. Sensors metered out good but I/o on cpu wasn’t chan...

If you call into the phone , programming is just like a Janus if I remember right.

Pm me your email

The rectifier on the relay board in the controller supplying the 150dv is probably bad.

And make sure tension isn’t too tight on spirator causing doors to bounce off interlock contacts

It turned out to be bad leveling sensors causing the issue

I’ve had issues with can inputs from push buttons not working but after a software reload everything work fine.

Do you have the backup software? I’d start by reloading software off that thumb drive.

What kind of silencer/ muffler does it have? Is it a inverted Schindler (dl Martin) jack?

Hudsonbay or Hudson.bay