Elevator Forum

if you have a very aggressive accel and decel, the operator will fault too because the belt slips a little and when it sees DCL, the count doesnt matc...

look on earlier post. this is very common. the resistor is 22 ohm i believe. definitely needs resistor, capacitor is negotiable. we take ours to ECI a...

should be able to drive down on car top or controller insp. hoistway will not work since pulse count has not been re-established (you can enter count ...

if you changed the limit, verify its position. You could increase LPE, but that should only be done for testing since it allows an error in the count....

The rotary switch is to use the LEDs to view the PMI I/O's the number on the dial correlates to PMI board.

both checked out ok. sent drive to access drive. LOL, now second car just loss logic board. Gotta love em. thanks guys for the help

already swapped motion adapter. going to have mech bring another MSU and relay pilot from another job/parts depot

yep, 621 =0 for encoder, base speeds are 1150 and speed limits are 1217. mvel-400. trying to get route mech to swap drive logic boards but customer is...

But all of the things here are based on AUTO, even runs slow on inspection though. I will try tomorrow. So far, no faults, dispatch is normal, EPC is ...

the encoder is a BEI 2048 encoder. I also installed a new one just for fun and no difference.

The speed board would not be coming in until 267 fpm?, We are "flat-topping" at 200 fpm. MSU and Drive PPR are both at 2048, now and before the proble...

I have the same issue on a duplex. it will not pull in my intermediate relay and stop at the next floor in both directions. It is a 400 fpm geared. If...

check supply power for dips. Also check you traveler for cuts. As it passes whatever has damaged it, you can hit a fast ground (and not blow the fuse ...

Scott, call me tomorrow if you need more info.

Per OSHA, a confined space is defined as a space you cannot readily walk out of. A pit that requires a ladder for egress, by definition is a confined ...