Elevator Forum

The 1098 is usually a bad N/C contact on the HDIF contractor or bobbling door locks. Your B-44 status is from the 1073, door lock monitoring. If DOL g...

Ya they are replaceable

When I was in construction we put them In the controller, even remote machine rooms. It wasn't until I went to service that I saw LN cards in the hois...

Find the LN card, it's either in the hoistway or in the controller. It will have CAT5 in and out. Check pico fuses and look for a slow steady flash ra...

If it's a TAC50. I think the output must be ok if the other riser works, probably a lamp. If it is a TAC50-03 or -04, it could be a lamp but it could ...

I just sent him a FAST Guide

I'd like to see that too

You need to call Thyssen to have your tech come out and take care of it. If the line to the machine room is active, he should have no problem.

All I have ever used is a megger and a meter but there have been a few instances on AC motors that would read fine but the motor was bad. Twice a pump...

Thanks I'll keep that in mind. We typically use Siemens but it sure is nice the S & S come in 240 volt.

Ya looking at the diagram I see you still need to upsize the starter like it was a 3 lead motor. Unfortunately, you have to go to a way bigger starter...

The car does run on inspect after a dead battery.

The tach on the motor isn't an O-ring, it's molded on