Elevator Forum

I think I’ve seen this when MSU adjustment Jog was set wrong

In this situation my AHJ says to make it work if the controller is capable. Otherwise it doesn’t have to.

Not that I know of.

Does the cam drop and is there an input the controller is looking for from the lock like a zone or at floor contact? I’ve never seen this setup it I w...

I think that’s your light curtain

This is a huge upgrade in my opinion. Go from a CPU that could barely run the elevator and talk to IMS at the same time to running on the exact same h...

I think you just need to plug into the other port. Or plug right into the board

But you could certainly make an adapter plug to adapt the TK run bug to the Savaria. I have a bag full of female 7 pin plugs so when I need to wire a ...

Set M107 to 0

Somewhere along this thread I forgot we were talking about GEN2s and looking back it looks like others did too. The GAL kit is only “engineered” to re...

Does it have an ERU battery lowering unit?

I sent you something. Pay particular attention to the latching relays on the Function Board print.

After comparing all the parameters to a running car in the building the only differences that could conceivably have to do with this is CS6 bits 4 &am...

The LN board definitely will need to be programmed so if the original isn’t bad, use it. I would replace the pico fuses with the correct size if you w...

Maybe reverse encoder signals A with A_