Elevator Forum

For intermittent problems on KCMs I start with detailing the controller connections. Especially pulling each wire on the non- screw terminal type plug...

And you won't be able to do a door scan if you are at a floor that is not valid by those parameters. That got me good one time trying to recover from ...

Garth is right, those should be 3. Those Params are not in the older software that does not support 84 & 85 CLC adjustments for door disco & p...

They probably never tensioned the ropes correctly when installed. Sometimes you end up chasing that loose rope that never got stretched like the rest....

I don't have much experience with these and I dislike EECO valves. But I am curious about your camera setup. What triggered the camera to alert you? I...

Must have been one of the LEMs. Thanks for the update.Are you saying they put 8mm ropes on a MOD?

Sounds like a limit or encoder problem. Check the belts, set the limits and do a real door scan first.

Oh, I assumed it was an MRL because of the rope tension monitor faults. I have never seen them on anything but. I certainly don't think the RTM should...

Was this an Isis II converted to steel ropes or did it start as a Synergy? I ask because so few Synergys came with 10K drives, I've only seen 1. The I...

I haven't got back there yet, maybe tomorrow. I was in that menu last time I was there but I don't remember seeing something to change or maybe secure...

Thank you

Anyone???

Sounds like a contactor problem. Do you see any voltage drop across the contacts?

Well at what point is it stopping? It does run on inspect in both directions? When you start the scan does it level down to the limit? Does DLB change...

It's not a bad idea especially when you consider how easy it is. You just need a folder called "tke" with a folder called "backup" inside. Also make a...