Elevator Forum

Any roped hydro, cheap TKE Aurora fixtures (Renaming them Enduro didn't make it better, go figure), PWM drives that destroy motor bearings and Virgini...

This is from machinedesign.comAll theoretical analyses of self-locking worm gears deal with static conditions. In such an analysis, the load on the wo...

Ahh the enthusiastic university student. Got to love 'em, they know so much and yet not enough to get it right. Have a university on service and the h...

This on has gotten a lot of us, you can do one of two things. At the door board switch the two center wires on the motor encoder plug, they are white ...

I'd make shue the doors are not relaxing off the secondary gate switch. Good luck and ALWAYS WORK SAFE.

Did/does this unit have the secondary gate switch, a kind of TK dpm switch? Some TIV and TAC 50's had these.

Late 2007 saw a mix of 32 and 16 bit and 2008 it was all 32 bit.

Si Kone no te da los datos del motor para arreglarlo estas fregado compa�ero. Yo no conozco ning�n taller que te puedo ayudar con eso, aqu� tienes que...

Check H paddles and carbons, hell check all paddles and carbons for proper wipe.

TK has been leaving manuals with the controllers. The OWNER should have the manual as well as the USB thumb drive. If they are not there the owner sho...

You probably have a 6300PY1, the wire goes from P24 on the terminal strip in the door operator to the feston on the board marked P24. Make sure the ju...

Hey Rick, brake is good and selector and tape clean, selector boards have been updated to latest revisions. And Oleeightball, this has a CPUA (32 bit)...

Same faults on all UIM shutdowns, 1904,1655 and 1030.1904- Detection of unintended motion1655- RGOK signal dropped1030- DLB/DLT active at same time.

Thanks as722 and your absolutly right, unfourtunately I have been down that road. This happens on 4 duplex banks scattered around the complex but neve...