Elevator Forum

Also, is the motor wired correctly? I seen one job that was noisy and drawing too much current when running full load, but did run, the motor leads we...

Is it a submersible or dry pump? Insulated (rubber bushing) pipe clamps? Tank unit on rubber? What kind of mufflers? In my opinion the only ones that ...

Thank yall, I appreciate it

If your getting your crip board sent out, have your sdoor, spoor 20, cdoor, and cdoor 20relays replaced too. Those are a pretty common failure point

Do you have the books for this? PM me if you need them

Not sure on this specific issue BUT, MCE tech support folks are human too and each person only knows what they know. Years ago I had an issue with a 4...

Pm me your email

Another issue somewhat common, this aint what your dealing with on this issue but could help someone else someday, if the toggle switch in the COP goe...

Yes, go to control panel then device manager then com ports. Port 1 should say acpi. If it doesn't, update the driver to acpi. I prefer to do this man...

That's IF your office actually knows your portal info.....I just called them and they emailed me the manuals.

After reading the part on it loosing memory and not even doing a hoistway setup, I'd call smartrise, sounds like they might need to put a sru board in...

I had a smartrise do this once. Set your contract speed higher, a good bit above actual running speed. Couldn't get it to go away any other way. Would...

What kind of Blain valve? A regular one or Bucher style variable voltage solenoid deal?

The 20 fault from the clc is just a byproduct of the selector giving a fault I believe