Elevator Forum

Sounds like a Solid setup with alpha and HW

This is true, if you halve your voltage and keep your hp the same your amperage will roughly double. I guess it depends on your goals. Is higher FLA b...

Sounds like it can be wired up low voltage and be good to go

And yes, you'd need a step up iso transformer to do this.

Only reason to do that would be if the motor voltage is higher than line voltage. Alot of gearless pm motors are in the 300-400v range and if your lin...

Whats the actual car speed? Make sure your valve is adjusted properly. You may be actually overspeeding. If necessary adjust down empty below contract...

It is supposed to come apart yes

Epoxy is the "I'm retiring in 2 years I don't care" option. Never used it but I've heard what you said, no leaks but you won't get it back apart.

Expando. When you absolutely don't want it to leak. Expando. Clean your pipe threads dry, brake clean is best here, put powder in a cup, use a water b...

By "it" moving l meant the problem

Sometimes there's no better troubleshooting tool than a second identical car that's running properly. If you swapped the brake modules and it didn't m...

If it was me and I was sending the board out, I'd have all the relays on it replaced. And scratch marks in them before sending the board out so you kn...

Either replace the CRIPHNA board or have it sent off and the cdoor and sdoor relays replaced (and the auxiliary ones, I think cdoor20 and sdoor 20). T...

Pm me your email

I have some prints and manual for the acme screw wheelovatoe vpl. Pm me