Elevator Forum

Even if the magnets are there, it's telling you it's not reading pulses from the encoder holes as it runs. In this case not reading any holes will thr...

You need to make sure the magnets are in the holders on your main sensor card in the selector. Without those the sensors on the aux sensor card can't ...

Not sure on the board. I thought the point of the tac 20-03 was LON was removed? You can get a standalone floppy disk reader with a USB cord end. I ke...

I have a feeling the market will work itself out eventually and companies will come and go. It's always been that way. But the timings less than taste...

Sounds like a great way to have corroded contacts over time.

And I don't mean I think everyone installing smartrise is a knucklehead. Obviously like your company there's alotta folks putting it in for other bene...

I do see the advantages of smartrise from the installation perspective. It is faster easier etc. Maybe I'm a little old school. To me a pre-wired cop ...

Glad to have you join us! I wish you good luck with your new company!

A big part of the problem in this trade is the push for controllers that require less and less knowledge to install. Companies want plug and play beca...

I have it though in a pdf. Pm me

Do you have a laptop with dmc fast on it? The help files on the dmc fast program on the laptop are actually written for the fast tool.

Loosing parameters with power outages sounds like a battery/battery backed RAM issue to me

Does it have a Dallas chip on the LCE CPU board? Those are battery backed RAM chips. When the battery goes bad in it your done. You can replace just t...

Personally, having gen 2s and other cars with coated steel ropes on my route. The idea of applying anything to the belts is borderline scary. I would ...

M-1-5-1