Elevator Forum

If the display goes blank then it could be doing a manual reboot on its own or a bad connection/ power supply. It should not go blank unless you push ...

Check that the brake is picking fully-grounds on motor or motor wiring-open motor winding-parameter set wrong. If all those are ok then the drive has ...

watch those thermal contacts-Ive seen a lot not wired in on many different brands ☹️

I had a Map Tool when I worked for K-Ive been at O for about 9 years and we picked up some of the units I had when I was in maintenance at K. Of cours...

It appears that they are part of Wheelavator/TKE

That will help the stroller and baby issue on escalators 🙂

Allied Electronics- www.alliedelec.com/ is my source for most board parts-there is also a local place in DFW that carries a ton of board components-Ta...

All I have to say is 4:1 !! ouch

Sent you a PM Aqua 🙂

pm me you email-I have some info I can scan and send to you

"yelling loudly!!!"

Very nice pics-thanks for sharing

Hey Bill, pm me your email and I have a doc you can use 🙂

check your slow down switches and ensure they are making up and breaking properly and when they are supposed to