Elevator Forum

Talked to Dale he suggested changing the oil,an using the 900 series or possible the extreme series.Does run hot,haven't checked complete piston yet.W...

TX get in first then get your six month in,then you can worry about school.You wont get any apprentice training until you done six month.So first year...

Well I have 10 of these in my area an parts an boards are becoming obsolescence.I would say bite the bullet an modernize this equipment.I would bet th...

Hey guys if its all about the money then i suggest you look else were.

Beon time ready to work personal phone only for emergencys no texting surfing the web an you got fifty percent of job licked.The days of being silent ...

check your travel cord,an car station something is taking those calls to ground.

I had similar button try adama SM452W5 survivor series the bolt up holes match plate.Also try looking at the Innovation Prestige series both very clos...

try removing jumper three for motor reversal if not three then two i had wrong direction a while back but cant recall for sure.if jumper already off p...

By chance is the valve from Linden if so return it there gunk.

talk to Dale at texicone an order the high temp ones also let the split seals set at least 24 hours before running machine.While you have it apart cha...

you probably smoked your header jumper on processor,alway swap for identical an if jumper on button board was cut,do the same an cut it.Ilearned this ...

Thank god your ok but thats why we test an verify or use a voltage sniffer an loto before reaching in.Never assume anything.

Thanks I am going there tomorrow an will check