Elevator Forum

Happy I could help.

You could try Miltronics in Ridgefield Park NJ.Their # is 201-931-1000. The owner was an engineer for CEC and has alot of experience with them and cou...

Tac 20's that were installed on my route in 2012 had this problem. It was software related and the adjuster installed some as yet un-approved software...

The incident at SUNY involved a mechanic from Al-an elevator which has been both a local 3 IBEW shop and non union.The incident at 285 Madison Ave. in...

As a previous poster said, you need an engineering degree to follow the prints. Their customer service is top notch , but if they had a traditional pr...

I can send you F3 error codes and prints if that helps.

Yes it moved up about 6 inches.

There are only 2 kinds of electrical problems. 1: Voltage where there shouldn't be 2: No voltage where there should be

Had a similar problem. Car was on the springs and trying to run down on auto.Selector was out. Would not go up on inspection. Safety circuit was up. T...

Had a bad 160 at a job less than 2 years old. Had to purchase a 240 for $1000. plus 60 feet of tape for $210. MCE was very generous and threw in the s...

If your Elgo160 fails the only option MCE offers is to upgrade to the 240 which means changing the tape as well. Ask me how I know.