Elevator Forum

The stall fault went away so far when I extended the stall timer. but now I get a Door Zone Aux failed off message. I just replaced both DZ relays and...

Honestly I really hate these controllers, and I am not fond of the selection system either. The way that the I/O's are set up is like the knew they we...

The tanks have heaters on them and I always adjust the valve after making a few long runs to make sure my oil is at operating temp. but yes it is almo...

Agreed

I had a TXR5 that did the same thing at a plant. They had no key switches though and no smokes. It was the craziest thing is every seen. I even manual...

That happened to me of my guys about 6 months ago. What type of controller/dispatcher? May just have to go to a board house and get a new board or you...

Well a forum wouldn't really be helpful to anyone if the solution wasn't documented

So I replace the 1036 com board and I get nothing. So i replace the CAN chip on the CT board and it works, but I have no PI and no Hall lanterns. So I...

Yeah I did this about a week ago. In the manual for the HPV900 that they send you it has all the wiring conversion charts from 600 to 900 to 900 serie...

Amarillo, Texas

Thanks for the help

yeah we already did that.

All of the SR that we have done have been overhead traction.. One was a 10 landing one was a 17. It was engineered with the IP8300 Selection system. h...