Elevator Forum

That's an esi controller. I think they called them Sysmacs. That's when Otis bought out cemco and ran them into the ground. I may have prints for them...

I might be installing one in the somewhat near future. If I do I'll take some pics

Cemco is now Custom Elevator and they still make a nice product.

The manual sucks but if you want I can walk you through how I do it. Their is a set of specialty tools that fit in the piston to hold up the sections ...

That's strange I don't think they've ever had that stipulation with us

The gen 2 aren't bad units, way better then the Kone ecos and the Schindler 3300. When you have them on you're route you just need to stock pulse moni...

I don't know the actual answer to that but I would think it would need some sort of reset after that.

Or you could use a Blaine KV 1P

Why not just replace the valve with a maxton? What controller is it? If it's a Montgomery you can usually change a dip switch on one of the boards or ...

Did you try removing the wires from the modules going to the hydrofit board and just put jumpers on them? That will determine if it's the fs modules o...

Sent

The best thing you can do is buy the new MEI direct replacement muffler that's just a normal muffler

What's your email

I have one page of a dover rotary print. It's the motor starter page edited for a soft start of that helps?