Elevator Forum

Yeah I attempted to. Since yesterday I had the Adon and cpu burn up. So now I've got a new drive, new cpu, and new Adon. My question is in which order...

ok went back to job and checked selector/magnet alignment and swapped all relays that could have been part of this problem. basically just tried to mo...

Magnets seem to be in right place. Job has been running in hotel for years. I used to have an ims CPU when I was with TKE. Now I have a world tool for...

Does anyone have an adjusters manual for the KCM 831. I have an installers manual but once there installed that doesn't help so much. I have added aro...

Yes I changed parameters 6-1, 6-2, 6-3, 6-4, 6-78, 6-79 and then saved those settings with 6-99=1. Then upon attempting to do a set up drive it wouldn...

Just got drive back from access and now getting f 8, f2 and f1. Does anyone have a manual on these Allen Bradley drives. I've verified all connections...

I dont have the procedures for setting up NTS and it is a dc job. I am going there in a couple hours to try a few more things. I will advise what i fi...

Thanks for reply. Yes they are the same and i did get the info i needed. I had a bad adon card. It was $2500 w/ trade in. I have bought entire control...