Elevator Forum

Whats involved in replacing main cpu board in these. Are they readily available from vert. Express

Can you pm me that info

Found bad contact on cgcf relay that kept run input low on softstart. Blue finders strike again

I had one shutdown today and as soon as i entered the 4 digit access code it started working

Could be the new 3D type. Is that code in the US yet?

Nope, just did a door scan with ims and than checked door operation with autocycle. It was just like programming the dover door op

Replaced board today. Had to do a little reading, set up is a better version than a dmc

Hey silly, can you get these boards pre-programmed from vertical express? Are these door ops set up the same way as a dover. I do have access to an im...

Silly, i didn't notice any flash drive. Step by step instructions would be great, never replaced this board before, thank you

sounds familiar. Are you hitting bottom limit before you learn hole count.

Looked in thumb drive and found them, thx silly